|
|
|
|
#1
January 23rd 2008, 17:20
|
||||
|
||||
|
presuming your 915 has coarse splinesin the ouputs, you can use 901 output flanges and VW type1 CVs on the inner end of the drive shaft or use 930 sized output flanges and 930 sized CVs on the inner end of the drive shaft. The other option (which I used) was to redrill the 930 sized output flanges for 944/type4/VW bus sized CVs and use the CVs that came with the driveshafts.
The drive shafts you need are the shafts that come from the same year/spec car as the trailing arms came from.
__________________
Subaru powered oval/1303 hybrid project 
|
|
#2
January 23rd 2008, 17:29
|
||||
|
||||
|
forgot to mention that T-1 cv's is not an option as i plan to put out 300hp/350nm.
Driveshaft should come from a 86/87 944 car then?
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
