|
I'm with Jim and Wally on this one especially confirming that you have a good rear specification. It seems as if the springing is overcoming the damping by a serious amount. Looking at your photos the rear end does not look too low and I see that you have polyurethane bumpstops mounted on the upper bracket rather than the alloy trailing arm but that should not make any difference. i would expect about 40mm+ clearance on the bumpstop at least in the static position. Are the Konis new? and do they work? It has been known for even new dampers of Koni's quality not to work properly. Have you a photo ofv the rear suspension in the static position with the wheel on the ground?
Clive
|
October 1st 2009, 07:29
Threaded Mode