measurement favour

[nilez]

I want to know the original angles of the holes where the hex bolt is in, So i can lower or raise the car from it's original heights, with the adjuster set in the middle.
Later i read that the hole angles were different from each other. the 15 to 25 degrees sounds familiar, but if possible i like to have the exact angles of the original bolts/holes.

thanks

[Hoghead]

My beam(s) do not have the brace between the tubes nor the right angle brace on the top tube.

Is this a mod or different year.

Any recommended mods to the beam while I am installing adjusters and it is stripped