Spyder Bait

[Humble]

I saw that sticker on the cart and I couldn't help but get a pic of the tranny up there.

The light housings I got off ebay and they are h4 conversion housings. Look for the autopal h4 housings because they give a very clean cut off line.

Break in update:
The motor is very strong and gets to 60 in a hurry. I'm only revving to 5000 until the first oil change but there's more in it. I found myself doing 80 in short order with the freeway flier without realizing it.

There's a few problems so far:
-reverse gear is non-existent, if I pull on the stick hard enough i can get teeth to grind but no engagement. I tried multiple shifters and adjustments but it's no good. Going to call Rancho on monday.

-One of the idle circuits is plugged, car runs on 3 cylinders until I get on the mains or hammer the throttle. I will probably pull all the idle jets and clean them.

-There's an oil leak near the pulley on the crank that is leaking pretty bad. It's not the oil pump and I think it's coming from the crank even with the sand seal.