CNC made aluminum Uniball rear suspension system

[-Alex-]

Bracket is the part that used to attach whole system to the arm Uniball bearing housing is aluminum.

Yes, i would too prefer aluminum, definetly the 7075 T6 series aluminum, but steel bracket is in this pricerange.

Strengths: Normal steel is 355N / mm2, 6082 T6 aluminum is 270N / mm2, 7075 T6 aluminum is about 500N / mm2

[-Alex-]

All test done again with 2000kg.


Uniball housing outer part stress chart

http://img845.imageshack.us/img845/9...keulkopuol.jpg


Uniball housing outer part displacement chart

http://img814.imageshack.us/img814/9...keulkopuol.jpg


Uniball housing outer part when load is 10 000kg, factor of safety is 0.85, notice the red little weak spots

http://img707.imageshack.us/img707/9...keulkopuol.jpg




Arm attachment part, FOS is 1.38 with 2000kg load.


Arm attachment part stress chart

http://img714.imageshack.us/img714/5...nikestress.jpg


Arm attachment part displacement chart

http://img845.imageshack.us/img845/3...kedisplace.jpg


Arm attachment part when load is 6000kg, factor of safety is 0.45, notice again the red little weak spots

http://img221.imageshack.us/img221/3...e16000kgyg.jpg

[Mr Big]

These look amazing. Will they work with the early steel arms?

[Humble]

I'm very interested in getting a set of these, how soon are you going to start making these and what kind of fulfillment time do you expect before getting them shipped?