Dave's new 1969 mild GL build...

[owdlvr]

Car has definitely had an accident in the front right corner, which may be part of the issue. Measurements I took suggest the frame head is good, but it could be the 30yr old cut and welded beam (for narrowing and lowering). I have a new 2" narrowed beam here I can swap in, but that might cause me some other issues. So instead, I re-dimpled the leaves, machined the end of teh upper beam tube and reinstalled...thus getting me the needed camber adjustment up front.

Tire clearance with the driver's side fender is still an issue, and I'm basically resigned to needing to purchase two front fenders for the car. Don't think I'll be rushing to that conclusion, but I also said I was going to do this build on a budget. So...

Lowered the rear end again the other night, but not enough, so it's out to the garage for attempt number three!