|
|
|
|
#1
February 12th 2005, 22:39
|
|||
|
|||
|
How hard is it to make a mold?
Question, I have some fiberglass running boards that I altered for four inch rear fenders and two inch fronts. I have a total of three Super Beetles and if possible I would like to install this type of running boards on all three. So I would like to make a mold or plug as it is also callled. Would making a plug be vey hard?
|
|
#2
February 12th 2005, 23:43
|
||||
|
||||
|
Well if you didnt mind the running board being slightly oversize you could just use the old ones as a mold.
__________________
67ghia, 2.3T mid engine conversion, tube frame dbl a-arm, rx7 brakes, currently in parts collection/bodywork stages.
|
|
#3
February 13th 2005, 00:39
|
|||
|
|||
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
