1952 GL update thread

[NO_H2O]

Originally Posted by petevw

Took a look inside the tunnel. 2 fuel, and 2 oil lines will be very tight around the nosecone of the 5spd. I'll grab a few small pipes tommorrow and see how/where they can fit in there.

Pete

If you have some line bending skills, you can bend the lines to tuck up in the body mounting bolt channel to run from front to rear and clamp them securly using some tabs at each body mount bolts. The pic I posted above was of a 912 that does not have the channel. I ran mine (fuel line) in the right channel so it would be protected. I will have to do 2 oil lines (1/2 inch) on the left side of mine when the oil cooler goes in the front bumper/spoiler. The heavy stainless is hell to flare for AN fittings. I bent everything then took it to a hydraulic shop to have them flared.