Mythbuster: continuing project thread of my 1303 '75

[Wally]

I knew if I wrote enough, there must be something that makes sense now and then
Cheers guys

Anyways, I finally remembered a little thing that was almost forgotten: maching the flywheel for the central pinion bearing...
Got that done today, so finally the flywheel and clutch are on the engine.



Also bought a set of new CV's for the outer sides only as these Lobro/GKN ones are quality but 4x as expensive as chinese Empi ones (assuming those are the cheap ones).
Hopefully I can finally put the engine in later this week and finish the install over the weekend.