|
|
#20
October 20th 2010, 16:55
|
|||
|
|||
|
OK I've been in the garage retrieving the sleeve from an old box..
By my great powers of measurement I get the PCD of the mount holes to 54mm & the holes are equidistant Diameter of the input shaft is 20mm at the widest Length of the sleeve is 60mm I have a car under wraps (from the weather) with the engine out but the bearing still on, so I could get someone to press the pedal & I can measure the travel of the bearing. I just have to get the time to unwrap it. cant do so until next week. An adaptor looks the way to go and easy enough to get made Last edited by Pablo; October 21st 2010 at 02:58. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode