Hydraulic throwout bearing type 1 IRS box

[Pablo]

After studying you pix a little closer I see GM on there, whats the number stamped on it?

[Luismj]

Originally Posted by Pablo

After studying you pix a little closer I see GM on there, whats the number stamped on it?

Part number GM 90 523 765.

Height 63mm
Height pressed 52mm (Correct 39mm)
Width 67mm
Base center center screw 63mm





I'm work on new adapter base to this solution, you see on the laptop. (center up lap. display)
But only for little clutch, imagine, blow and need remove engine...

[al_kaholik]

Not the bolt on solution we were looking for then!

Maybe worth investigating some more bearings or some kind of adapter plate...

Unless SteveC knows something that we don't?

I'm not too bothered cause I got this for a song and can sell it on.

[Steve C]

Originally Posted by al_kaholik

Unless SteveC knows something that we don't?.

Hi

I bought to fit in a G50 but in the end I decided to stick with the G50 mechanism.

Steve

[al_kaholik]

Did think this after reading. Still liking the idea and will be looking more at an adapter, it is a far superior system

[tumba]

This might be something to have a look at:

http://www.pegasusautoracing.com/pro...asp?RecID=4625

I'm considering it for my Webster Mk dogbox

[Luismj]

Originally Posted by al_kaholik

Not the bolt on solution we were looking for then!
Maybe worth investigating some more bearings or some kind of adapter plate...
Unless SteveC knows something that we don't?
I'm not too bothered cause I got this for a song and can sell it on.

al_kaholik

i'm sorry for the quality because take the picture and press the slave it so hard....
is more shorter than I specified previously. (pressed 39mm)

http://i712.photobucket.com/albums/w.../IMAGE_872.jpg
http://s712.photobucket.com/albums/w...MAGE_878-1.jpg
http://s712.photobucket.com/albums/w.../IMAGE_875.jpg
http://s712.photobucket.com/albums/w.../IMAGE_874.jpg
http://s712.photobucket.com/albums/w...r/BB_009-7.jpg